AgroClient 1.1.3

Description:

AgroClient 1.1.3

Agrothon Client
A Client for Agrothon Running in Raspberry Pi










Installation


First Install the dependencies
sudo apt-get update
sudo apt-get install python3-opencv python3-rpi.gpio



from Pypi
pip3 install AgroClient



From git
pip3 install -U git+https://github.com/viswanathbalusu/Agrothon-Client



Using Docker


First install docker
curl -sSL https://get.docker.com | sudo sh
sudo usermod -aG docker ${USER}



Get the docker-compose.yml and agrothonclient.env to a local directory
wget -q https://raw.githubusercontent.com/viswanathbalusu/Agrothon-Client/main/docker-compose.yml
wget -q https://raw.githubusercontent.com/viswanathbalusu/Agrothon-Client/main/agroclient-sample.env -O agroclient.env



Edit the Variables in agroclient.env and start docker container
pip3 -q install docker-compose
docker-compose up -d



Docker method only works one arm-v7 host OS




Usage
usage: AgroClient [-h] -y HOSTNAME -a APIKEY [-u USB] [-p1 PIR1] [-p2 PIR2]
[-p3 PIR3] [-p4 PIR4] [-br BAUDRATE] [-r RELAY]

optional arguments:
-h, --help, show this help message and exit
-y, --hostname HOSTNAME, API Server host name
-a, --apikey APIKEY, API Key of host
-u, --usb USB, USB Port of Arduino
-p1, --pir1 PIR1, GPIO Pin of PIR1
-p2, --pir2 PIR2, GPIO Pin of PIR2
-p3, --pir3 PIR3, GPIO Pin of PIR3
-p4, --pir4 PIR4, GPIO Pin of PIR4
-br, --baudrate BAUDRATE, Baud rate of USB Port to read sensor data
-r, --relay RELAY, Relay Signalling GPIO pin

Circuit Diagram

Hardware

Pin Configuration (Default)


Raspberry Pi



GPIO
Device
Use
Mode




12
Relay
To Switch on/off Relay
OUT


25
PIR1
Motion Detection
IN


8
PIR2
Motion Detection
IN


7
PIR3
Motion Detection
IN


1
PIR3
Motion Detection
IN





Arduino nano



Pin
Device
Device pin
Mode




A0
Moisture Sensor*
Analog Out
IN


D12
DHT11
Signal
IN



* For multiple sensors use differnet Analog pins


Connect the Pi camera to CSI Port


Use SSH to access the terminal and run the Python Code


Connect all the Vdd's and GND's to 5V and GND (or as per instructions given in spec sheet)


Note


To get the USB Device ID, Use
ls /dev/tty*

Most Probably the Value will be /dev/ttyUSB0


Sensor data should be sent in the following pattern
mositure1,moisture2,moisture3, .... ,moistureN, Temperature,Humidity
ex : 55.29,52.59,32.5,65.26