autocloudreporter 1.0.3

Description:

autocloudreporter 1.0.3

autocloudreporter is a fedmsg consumer for reporting Autocloud
results to ResultsDB. It listens out for Autocloud fedmsg messages, and
submits results using the resultsdb_conventions module for conveniently
reporting results in ‘conventional’ format.
The code was written with Python 3 in mind, but it turns out that
verification of fedmsg message signatures does not currently work in
Python 3, so it should be run under Python 2 for now.

Requirements
Python libraries:

fedmsg
fedfind
resultsdb_api



Installation
Install the required external Python libraries, then use setuptools to
install, e.g.:
python setup.py install


Test and production modes
Two consumers are provided, a ‘test’ and a ‘production’ consumer. For
‘test’:

The consumer listens for dev (not prod) messages
The consumer does not validate message signatures
The consumer reports to a ResultsDB instance running on localhost
port 5001

In this mode it is safe to play around with the consumer, and you can
use a tool like fedmsg-dg-replay to trigger event creation by
replaying a relevant fedmsg (which will show up with a dev topic
rather than prod).
For ‘production’:

The consumer listens for prod (not dev) messages
The consumer validates message signatures
The consumer reports to the production ResultsDB instance (if
permitted)

PLEASE do not enable the production consumer on a system authorized
to submit results to ResultsDB without checking with Fedora QA.
The fedmsg config keys for the consumers are
autocloudreporter.test.enabled and
autocloudreporter.prod.enabled respectively.


License
autocloudreporter is released under the GPL, version 3 or later. See
COPYING and the header of autocloudreporter.py itself.